Anna University, Chennai Nov/Dec 2012 Examinations
Rejinpaul.com Important Questions
ENGINEERING THERMODYNAMICS ME2202
Unit I-V
1.    A paddle wheel fixed to a shaft of an engine revolves in a closed hollow vessel containing water. This closed vessel is connected freely on the shaft and restraint to its turning moment is proved by mass attached to its side. Find the temperature rise for the following observations.
Engine rpm = 650, Load applied = 60 kg at a leverage of 1.2m,
Quantity of water = 200 kg
Duration of test
2.    A cylinder contains 0.45 m3 of gas at 1 x 105 N/m2  and 80oC. The gas is compressed to a volume of 0.13 m3, the final pressure being 5 X 105 N/m2. Determine i) The mass of gas ii) The value of index ‘n’ for compression The increase in internal energy of the gas and iv) The heat received or rejected by the gas during compression. Take γ = 1.4 R = 294.2 J/kg K
3.    A turbine operates under steady flow condition receives steam at the following state pressure = 1.2Mpa, Temperature =1880C, Enthalpy = 2785 kJ/kg, velocity = 33.3m/sec and elevation = 3m. The steam leaves the turbine at the following  state: pressure = 20Kpa, Enthalpy = 2512 kJ/kg, velocity = 100m/sec and  elevation = 0m. Heat is lost to the surrounding at the rate of 0.29kJ/sec. If the rate  steam flow to the turbine is 0.42kg/sec what is the power output of the turbine in KW
4.    Three grams of nitrogen gas at 6atm and 160
c is expanded adiabatically to double its initial volume, then compressed at constant pressure to its initial volume and then compressed again at constant volume to its initial state. Calculate the net work done on the gas. Draw P-V diagram for the process. Specific heat ratio of nitrogen is 1.4.
5.    One litre of hydrogen at 273 K is adiabatically compressed to one-half of its initial volume. Find the change in temperature of the gas, if the ratio of two specific heats for hydrogen is 1.4
6.    An Engine-working on Otto cycle has a volume of 0.45 m3 , pressure 1 bar and temperature 30o,C at the beginning of compression stroke. At the end of compression stroke, the pressure is 11 barand 210 KJ of heat is added at constant volume. Determine (i) Pressure, temperature and volumes
at salient points in the cycle.' (ii) Efficiency
7.     Derive the expression for thermal efficiency of a Carnot cycle with its p-V and Ts Diagram?
8.    A Carnot engine takes heat from an infinite reservoir at 5500C and rejects it to a sink 2750C. Half of the work delivered by the engine is used to run generator and the other half is used to run heat pump which takes heat at 2750C and rejects it at 4400C. Express the heat rejected at 4400C by the heat pump as % of heat supplied to the engine at 5500C. If the operation of the generator is 500W, Find the heat rejected/hour by the heat pump at 4400C?
9.    Establish the inequality of Clausius and express Entropy change in irreversible process
10.1 kg of steam initially dry saturated at 1.1 MPa expands in a cylinder following the law PV113 = C. The pressure at the end of expansion is 0.1 MPa. Determine  (i) The final volume (ii) Final dryness fraction (hi)  Work done (iv) The change in internal energy  (v) The heat transferred
11.Draw the p-V diagram of pure substance and explain its various regions of the diagram in details?
12.with help of T-s diagram explain the various process of ideal Rankine’s cycle and derive the efficiency in terms of enthalpy?
13.Steam at a pressure of 15 bar and 250C expands according to the law PV1.25 = C to a pressure of 1.5 bar. Find  the final conditions, work done, heat transfer and change in entropy. The mass is 0.8 kg
14.Derive clausius-claperyon equation
15.Deduce the Maxwell relations from thermodynamic property relations?
16.Using Clausius Cleperyon’s equation, Estimate the enthalpy of vaporization at 2200C saturation temperature. Take the following data Ts = 2200C; vg = 0.08603m3/kg; vf =0.00119m3/kg.
17.2kg of air at 300C, 65% RH is mixed adiabatically with 5kg of air at 200C, 10%RH. Determine final condition of the mixture?
18.Give short notes on following (a) Specific humidity (b) Relative humidity (c) Dew point temperature (d) Wet bulb depression
19.Air has a dry bulb temperature of 250C and wet bulb temperature of 150C. If the barometer reads 1bar, Calculate
(a) Vapour pressure
(b) Specific humidity
(c) Saturation ratio
(d) Relative humidity
(e) Dew point temperature
(f) Vapour density
(g) Enthalpy of mixture
0 comments:
Post a Comment